![]() |
| Diagram illustrating the parts and locations of a wooden toy freighter; some measurements too. |
A colorful Toy Freighter for quantity production boats are among the most fascinating toys for young children. If they can play with a boat in the bathtub or in a wading box or pool, so much the better, but they also get much enjoyment in playing with one on the floor if it is of a flat-bottomed type.
The little freighter illustrated is adapted for either purpose, and the design is especially well suited to quantity production because of its simple construction and the small amount of materials required. The capacious cargo hold will carry a large shipment of dummy boxes and barrels made from scraps of wood.
White pine, redwood, or any fairly lightweight wood may be used. The hull is built up as shown and fastened with casein glue to a waterproof plywood bottom. The plywood should be of the outdoor type. Avoid using nails or brads unless galvanized, because ordinary nails will eventually cause rusty streaks.
Deck planking can be simulated by scoring the wood with a hard lead pencil and then varnishing the surface. Take care to round off the tip of the mast as well as that of the dowel behind the deck house. If the toy is intended for a very small child, the mast should be eliminated so that there would be no danger of his falling upon it.
Use the brightest reds and greens in painting, because the appeal of this freighter lies principally in its coloring. Stenciled windows and doors add to its appearance, but are not absolutely necessary. The cargo hold is painted gray.

No comments:
Post a Comment
Constructive comments are appreciated. All comments are moderated and do not immediately appear after publishing. I don't publish spam folks. Thanks and have a nice day!
Note: Only a member of this blog may post a comment.