To make this nature lover's bird house ornament, you will need to collect the following supplies: several large pine cones, hot glue and hot glue gun, jute twine, white school glue, scrap cardboard from cereal box, a small plastic cup, masking tape, pliers and a utility knife of some kind.
Step-by-Step Instructions:
- Use pliers to remove the scales from the pine cones. Discard damaged and split scales.
- Cut a round for the roof of the birdhouse from the cardboard. To give this a slight peak, mark the exact center of the round and cut a slash to the center from one side. Gently curl the cardboard round and tape it in place.
- Next, use masking tape to attach the roof to the plastic cup.
- Cover the rest of the cup with masking tape.
- Cut a small hole in the side of the cup where you want your birds to enter the house.
- Punch in a small hole beneath this entrance to push a small twig or cut skewer through for the perch beneath the birdhouse 'door.'
- Now cover the walls of the birdhouse with twine. Do this by brushing on white school glue to the outer surface and winding the twine around and around until the surface is covered.
- You may wish to cover the perch with the twine as well.
- Taking a hot glue gun, squeeze out a small amount of glue to attach the first pine cone scale along the lower part of the birdhouse roof. Make sure this hangs off the edge of the roof by approximately 1/2".
- Glue the next scale next to the first and so one all the way around the roof's edge.
- Then all the second level of scales ('roof tiles') above the first level and so on until the peaked roof has been covered evenly to the top. (see photographs above.)
- You may wish to hot glue a small red mushroom bird to the perch once your birdhouse ornament has dried.


No comments:
Post a Comment
Constructive comments are appreciated. All comments are moderated and do not immediately appear after publishing. I don't publish spam folks. Thanks and have a nice day!
Note: Only a member of this blog may post a comment.