Wednesday, November 18, 2026

How to Make a Vintage Organ Grinder Toy

Front side, and open rear view of the animated organ-grinder toy.
 The sand motor is "wound" by turning the house sidewise through a
complete revolution as shown at the far left.

      An everlasting sand motor provides the power to drive the mechanical organ grinder illustrated. To “wind up” the mechanism, it is necessary merely to give the box a complete turn in the direction indicated in the drawings. This brings the sand back into the hopper ready to run down and turn the small paddle wheel. Other adaptations will suggest themselves, such as a woman pumping water or a hobo sawing wood.
      For the box, plywood is used, the joints being well fitted to prevent leakage of sand. The six-bladed paddle wheel is scroll-sawed from a block of white pine. The axle is a piece of bicycle spoke turning in glass-bead bearings, which are recessed into the wood as shown. Short lengths of brass tubing will serve just as well as the beads.
      The hole in the sand hopper should not be over 1/8″ in diameter for beach sand. Incidentally, beach sand is the best because the grains are smooth and pour more readily. Sand from a creek bed is also satisfactory. To facilitate adjustment, the back panel with the window is fastened with No. 3 screws.
      The organ grinder is scroll-sawed from material and painted in bright colors. The girl is painted on cardboard, together with the window frame, and glued to the box, as is the hand organ.—L. R. Browne.

See the inner mechanics for this vintage toy above.

No comments:

Post a Comment

Constructive comments are appreciated. All comments are moderated and do not immediately appear after publishing. I don't publish spam folks. Thanks and have a nice day!

Note: Only a member of this blog may post a comment.