![]() |
| See in detail how the turtle is assembled. |
When pulled, on a string, the wooden turtle illustrated below moves its legs and draws its head in and out in a lifelike manner.
Turn the shell from a band-sawed pine blank. Hold it in a chuck for recessing, and then fit the recess to another chuck for shaping the outside. Groove the segment zones and divide them radially.
Bend the crankshaft from baling wire, the bearing from a strip of sheet iron. The connecting rods are strips of sheet iron, pushed onto the cranks before the wheels are added. The latter are keyed by bending the shaft ends back on themselves and forcing them into small holes in the wheels, where a drop of celluloid cement holds them. Screw the bearing inside the recess, slit the ends to the bearing holes, and force in the crankshaft.
Shape the head and neck semicircular on top. The neck slides in a groove in the shell, being held with a metal plate. The connecting rod enters a slot, where a nail holds it. The tail is a strip of inner-tube rubber.
Bend the crankshaft from baling wire, the bearing from a strip of sheet iron. The connecting rods are strips of sheet iron, pushed onto the cranks before the wheels are added. The latter are keyed by bending the shaft ends back on themselves and forcing them into small holes in the wheels, where a drop of celluloid cement holds them. Screw the bearing inside the recess, slit the ends to the bearing holes, and force in the crankshaft.
Shape the head and neck semicircular on top. The neck slides in a groove in the shell, being held with a metal plate. The connecting rod enters a slot, where a nail holds it. The tail is a strip of inner-tube rubber.

No comments:
Post a Comment
Constructive comments are appreciated. All comments are moderated and do not immediately appear after publishing. I don't publish spam folks. Thanks and have a nice day!
Note: Only a member of this blog may post a comment.